It is crucial to have a good look at the sensor before you clean it with any wet or dry tool. If you see any big particles or grit, you must try to blow them off, otherwise they could cause problems. We’re proud to present the SensorView, an LED illuminated magnifier (3X) that will enable you to check your sensor’s dust and debris status before and after cleaning. This tool and a blower like the Giottos Rocket are just about mandatory for safely cleaning your sensor.
FEATURES:
• Compact size of 2" X 4½" X ¾"
• A sliding protective sleeve protects the lens when not in use
• Crystal clear lens with a sharp, distortion-free view
• LED turns on by sliding the sleeve to the full-open position
• 3 Panasonic Alkaline Plus batteries are included
*This item is available everywhere with a shipping cost of $8.95.
"Life being short, we employed the $14.95 SensorView from Copper Hill Images. It has a generous two-inch diagonal 3x magnifier with a bright LED lamp in a compact, portable case. Having the lamp below the magnifier lens was a big help: no shadows. The SensorView saved us quite a bit of time with a troublesome cleaning job recently that required several attempts to clean the sensor."...................Mike Pasani:: www.imaging-resource.com
Add this product to your cart below
under 'ordering options'.
|
